DRAFT
TM 5-4210-249-13&P-2
0152
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
TFFT02622
WARNING
ICON 3
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
Step 16.
Put EMERG MASTER and F/R LOWER WARNING switches to off position (WP 0004).
Turn Service Drive Lights Off (TM 9-2320-347-10). Remove driver side front lower
warning light (WP 0351). Turn Service Drive Lights On (TM 9-2320-347-10). Put
EMERG MASTER and F/R LOWER WARNING switches to on position (WP 0004).
With a test lead set, check for 22 to 28 VDC across main wire harness wire 1610 (black)
from main wire harness warning light connector, terminal 3 to a known good ground.
If 22 to 28 VDC are not present, repair wire 1610 in main wire harness if
repairable (TM 9-2320-325-14&P), or replace main wire
harness (WP 0455).
Step 17.
Put EMERG MASTER and F/R LOWER WARNING switches to off position (WP 0004).
Turn Service Drive Lights Off (TM 9-2320-347-10). Turn battery disconnect switch to
OFF position (WP 0007). With a test lead set, check for continuity across main wire
harness wire 1640 (black) from main wire harness warning light connector, terminal 1 to
a known good ground.
a.
If there is continuity, replace driver side front lower warning
light (WP 0351).
b.
If there is no continuity, repair wire 1640 in main wire harness if
repairable (TM 9-2320-325-14&P), or replace main wire
harness (WP 0455).
0152-11