|
| |
TM 5-4210-233-14&P-1
5-43. FORWARD TANDEM AXLE AND DRIVE UNIT-Continued
(62)
Remove the wood block from between ring gear (19) and carrier housing (5).
(63)
Put a holding tool on input yoke and torque nut (24) to 600 to 800 lb ft (813 to 1084 N•m).
(64)
Check end play of input shaft (25).
(a
Rotate the input shaft (28) in each
direction and push the yoke (23)
toward the bearing cage (28). This will
make sure the input shaft assembly
(29) is at the bottom of its travel.
(b) Use a dial indicator and mount to
differential carrier housing (5). Place
the indicator pointer against the top of
the input shaft (25). Set the dial
indicator to zero.
(c) Use a pry bar and a support to push
the input yoke away from the
differential carrier housing (5). Read
the dial indicator. Reading must be
0.002 to 0.008 inch (0.050 to 0.200
mm).
(d) If end play of input bearing (33 and 50)
is not within specifications, add or
remove shims (30) from shim pack as
described above.
(65) Install output bearings (17) and output
shaft (1 6) in bearing cage (28) as follows.
(a) Lubricate the bearing cups (18) and
cones (17) with axle lubricant (item 45,
Appendix E). Replace bearing cups
(18) and cones (1 7) as a complete set.
(b) Install the two bearing cones (17) on
the output shaft (16) by pressing
on output shaft (16).
(c) Place the output bearing cage (13) in a
vise with soft jaws. Use a press or
sleeve to press internal bearing cup
(18) in bearing cage (13). Two bearing
cones (17) must be pressed onto shaft
(16). Install outer bearing cup (18) into
position in output cage (13) and press
into position over bearing cone (17).
5-318
|
