|
| |
TM 5-4210-233-14&P-1
5-28. DDEC ELECTRONIC CONTROL MODULE AND SENSORS - Continued
b.
DDEC Electronic Control Module.
(1)
Removal.
(a) Refer to step a. above and
disconnect wiring harnesses
from control module (13).
(b) Disconnect two fuel hoses
from fitting block (7).
(c) Remove four screws (6) and
lockwashers (5). Remove
eight isolator mounts (4).
(d) Remove control module (13)
with
attached
parts
from
engine.
(e) Remove two screws (9) and
remove fitting block (7) and
seals (8) from plate (10).
Discard seals.
(f)
Remove eight screws (11)
and remove heat shield (12)
and plate (10) from control
module (13).
(g) Remove screws (3, 15, 16
and 17), lockwashers (2 and
5) and flat washers (1) and
remove bracket (14) from
engine.
(2)
Cleaning and Inspection.
(a) Wipe all parts clean with a dry, clean, lint free cloth (Item 42, Appendix E).
(b) Inspect control module (1 3) for damage to electronic receptacles.
(c) Inspect fitting block (7) for damage.
(d) Replace ail damaged components.
5-185
'
|
