|
| |
TM 5-4210-233-14&P-1
5-22.
BLOWER REPAIR - Continued
NOTE
There are six measurements between rotors and
housing made through top of blower.
(61)
Using 0.015-in. (0.381 mm) feeler gage, check
clearance between rotor lobes (29 and 30) and
housing (7) while rotating rotors. If clearance is
not correct, replace housing.
NOTE
There are six measurements between
rotors and housing made through bottom
of blower.
(62)
Using 0.004-in. (0.102 mm) feeler
gauge, check clearance between
rotor lobes (29 and 30) and blower
housing (7) while rotating rotors.
If clearance is not correct, replace
housing.
5-141
|
