|
| |
TM 5-4210-233-14&P-1
5-22. BLOWER REPAIR - Continued
NOTE
Use five screws with puller tools on timing gears. Use 5/16 in.-
24 x 1-1/2 in. (38 mm) screws and align with tapped holes in
gears.
(5) Install puller tool on ieft timing gear (13) with two screws.
(6) Install puller tool on right timing gear (14). REAR END
CAUTION
If puller screws are not tightened evenly
during removal of timing gears damage
may result to gears.
(7) Tighten screws (15) evenly to remove
gears (13 and 14).
(8) Remove pullers from gears (13 and 14).
(9) Mark rear end plate to indicate top.
(10) Remove, tag and mark shims (16) and
two spacers (17) from each rotor shaft
(18).
(11) Remove front end plate cover (19)
and gasket (20) by removing nine
bolts (21).
5-125
|
