Cleaning and Inspection -706880821

TM 5-4210-233-14&P-1

5-23. TURBOCHARGER-Continued

Cleaning and Inspection.

WARNING

Adhesives, solvents, and sealing compounds can burn

easily, can give off harmful vapors, and are harmful to skin

and clothing. To avoid injury or death, keep away from

open fire and use in well-ventilated area. If adhesive,

solvent, or sealing compound gets on skin or clothing, wash

immediately with soap and water.

Dry cleaning solvent P-D-680 is potentially dangerous.

Avoid repeated and prolonged breathing of vapors and skin

contact with the liquid. Do not use near open flame, arcing

equipment or other ignition sources. Always wear eye

protection and protective clothing. The flash point of P-D-

680 is 100 to 138 deg. F (38 to 59 deg. C).

NOTE

Do not use a caustic cleaning solution. It can damage parts.

(1) Soak metal parts in dry cleaning solvent (Item 3, Appendix E) for 25 minutes.

CAUTION

Do not clean with steel bristle brush. Turbocharger parts can be

damaged by steel bristles.

(2) Clean parts with stiff bristle brush after soaking in dry cleaning solvent (Item 3, Appendix E).

(3) Clean oil passages (1, 2, and 3) in center housing (4) and oil passages (5 and 6) in backplate (7).

(4) Clean oil inlet hose inside and out. If oil hose is damaged or deteriorated, replace it.

5-151