Assembly-continued -706880777

TM 5-4210-233-14&P-1

5-18. ALTERNATOR - Continued

(21)

Install drive end frame (9), with

rotor shaft through bearing in

stator frame (20). Align match-

marks when installing stator

frame. Remove tape from stator

frame bearing.

(22)

Brushes must be pinned in

retracted position to allow slip

rings to enter frame. Brush pin (A)

(Item 93, Section III, Appendix B)

must extend through rotor housing

to allow removal.

(23)

Install thru bolts (11) in frames. Tighten thru bolts

to a torque of 50 lb in. (5.5 N.m).

(24)

Remove brush pin (A) from assembled atemator.

(25)

Mount alternator in a suitable test stand. A 12 volt fully charged battery should be available. Install

alternator in a test installation and make electrical connections as shown below with carbon pile

turned off.

5-107