SECTION I. REPAIR PARTS, SPECIAL TOOLS, TEST MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE) AND SUPPORT EQUIPMENT

TM 5-4210-233-14&P-1

SECTION I. REPAIR PARTS, SPECIAL TOOLS,

TEST MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE)

AND SUPPORT EQUIPMENT

5-1.

COMMON TOOLS AND EQUIPMENT. For authorized common tools and equipment, refer to the

Modified Table or Organization and Equipment (MTOE) applicable to your unit.

5-2.

SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. No special tools, TMDE, or support

equipment are required by Direct Support Maintenance for the maintenance of the firetruck.

5-3.

REPAIR PARTS. Repair parts are listed and illustrated in Appendix F of this manual.

SECTION II. SERVICE UPON RECEIPT

5-4.

SERVICE UPON RECEIPT. See para 4-4.

SECTION III. TROUBLESHOOTING

5-5.

INTRODUCTION. This section contains step-by-step procedures for identifying, locating, isolating,

and repairing equipment malfunctions.

5-6.

TROUBLESHOOTING INSTRUCTIONS. The System Symptom Index, table 5-1, lists common

malfunctions which could be found during maintenance of the firetruck or its components.

a. Table 5-2 lists malfunctions which can occur during operation or maintenance of the firetruck or its

components. Each malfunction is followed by a list of tests or inspections which will help to determine

corrective action to be taken. Perform these tests, inspections, and corrective actions in the order

listed. Operation of a vehicle without a preliminary examination can cause further damage to a

disabled component and possible injury to personnel. By careful inspection and troubleshooting, such

damage and injury can be avoided. In addition, cause of faulty operation of a vehicle or component

can often be determined without extensive disassembly.

b. This manual can not list all malfunctions that may occur, nor all tests or inspections and corrective

actions. If a malfunction is not listed or is not corrected by listed correctable actions, notify your

supervisor.

5-3