Disassembly-continued -706880740

TM 5-4210-233-14&P-1

5-14. STARTER REPAIR AND TESTING-Continued

(9)

Cut commutator (1 5) as required on lathe. When cutting commutator, cut no more than 0.005 in.

(0.13 mm) at a time to remove scoring, pits, burrs, or to return commutator to round. Then make

final cut of 0.002 in. (0.051 mm). Undercut mica (16) 1/32-in. (0.8 mm) deep and 1/32-in. (0.8

mm)

wide. Blow off all loose copper and mica particles with compressed air.

(10)

Polish commutator (15) with abrasive paper.

(11)

Remove seven screws (17), lever housing (3), and drive housin (4).

(12)

Remove five long screws (18), one

short screw (19), and drive housing (4)

from lever housing (3).

(13)

Remove starter drive (20) and

preformed packing (21).

(14)

Remove retaining ring (22) and shift

lever shaft (23) from lever housing (3).

(15)

Remove large preformed packing (24)

and small preformed packing (25) from

shift lever shaft (23).

5-70