Installation -706880733

TM 5-4210-233-14&P-1

5-12. STARTER MOTOR - Continued

b. Installation.

(1)

If necessary, remove three screws (13) from back of starter motor and install bracket (2) with screws

(1 3). Use holes "A", "B" and "C" when mounting bracket (2) to starter motor. Hole "C" should align

with brush cap "F" on starter motor.

(2)

Install new gasket (9) on face of starter (8).

(3)

Slide starter (8) into flywheel housing to engage starter drive with flywheel ring gear.

(4)

Hold starter in position and install three lockwashers (1O) and screws (11) to secure starter. Torque

screws to 137-147 ft lb (186-200 Nm).

(5)

Install two screws (1) and flat washers (12) through holes "D" and "E" of bracket 2. Install spacers (3),

lockwashers (5) and nuts (7).

(6)

Using tags for identification, connect engine harness wires to starter motor ground terminal (1 4) and

solenoid BATTERMINAL (15).

Follow-on Maintenance.

(1) Connect batteries (see para 4-114).

5-63