SECTION I. REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT

TM 5-4210-233-14&P-1

Contents

Para

Page

APU BRUSHES ................................ ................................ ................................ .. 4-208

4-520

APU ANTI-FLICKER POINTS AND RESISTOR ................................ .................. 4-209

4-522

APU PRIMARY FUEL FILTER ................................ ................................ ............ 4-210

4-524

APU SECONDARY FUEL FILTER ................................ ................................ ...... 4-211

4-525

APU OIL FILTER ................................ ................................ ................................ . 4-212

4-526

APU AIR CLEANER ................................ ................................ ............................ 4-213

4-527

APU GLOW PLUG AND AIR INTAKE HEATER ................................ .................. 4-214

4-529

APU EXHAUST SYSTEM................................ ................................ .................... 4-215

4-530

APU FUEL TRANSFER PUMP................................ ................................ ............ 4-216

4-532

APU OIL PRESSURE SWITCH................................ ................................ ........... 4-217

4-533

APU CRANKCASE BREATHER................................ ................................ .......... 4-218

4-534

MITER BOX ................................ ................................ ................................ ........ 4-219

4-536

PREPARATION FOR STORAGE OR SHIPMENT ................................ ............... 4-220

4-541

SECTION I. REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT

4-1. COMMON TOOLS AND EQUIPMENT. For authorized common tools and equipment refer to the

Modified Table of Organization and Equipment (MTOE) applicable to your unit.

4-2. SPECIAL TOOLS, TMDE AND SUPPORT EQUIPMENT. There are no special tools, TMDE and support

equipment required for the fire truck.

4-3. REPAIR PARTS. Repair parts for this equipment are illustrated and listed in Appendix F of this manual.

SECTION II. SERVICE UPON RECEIPT

4-4. INTRODUCTION. This paragraph provides instructions for preparing a new, reconditioned, or recently

transported tuck for operation. Refer to Chapter 3, Lubrication Instructions and fluids.

CAUTION

Due to the critical nature of the service for which this vehicle is

intended, no vehicle should be placed in service if there is any

doubt or evidence of improper function of any of the

components or systems.

a. Pump Body, Hose Body.

(1)

Inspect body for shipping damage; minor damage (e.g., scratches, small dents) should not affect

truck function. Major damage should be repaired prior to use and all items adjacent to the damage

should be thoroughly checked for correct operation.

(2)

Check all doors, latches, and hinges operate correctly; replace any which are defective. Refer to

para 4-71 and para 4-77 .

(3)

Check all lamps and beacons for dirty or broken lenses. Clean or replace as required. Refer to

para 4-61 through 4-66 .

4-5