|
| |
TRUCK SERVICE MANUAL
TM 5-4210-230-14&P-1
REASSEMBLY
Using a jet wrench, SE-1772-6, in-
stall the secondary main jets (Fig. 31).
Using a socket wrench, SE-1772-1, in-
stall the power valve (where used)
using a new gasket (Fig. 30). Both
primary and secondary valves are
stamped for identification. The prop-
er power valve (where used) must be
installed in each metering block.
Install the idle adjusting needles
using new gaskets. Turn the needles
in gently until they touch the seat,
then back them out the correct amount
of turns (Fig. 50). (See SPECIFICA-
TIONS.) Do not force the needles a-
gainst their seats. If a needle is
damaged, it must be replaced before
a proper idle mixture adjustment can
be obtained.
Refer to Step 13 through 15 and in-
stall the metering block, fuel bowl,
gaskets and spring loaded bowl screws.
When the preceding steps have been
completed, the carburetor is ready
for installation.
CGES-125-T Page 33
PRINTED IN UNITED STATES OF AMERICA
|
