|
| |
ENGINE DIVISION SERVICE MANUAL
TM 5-4210-230-14&P-1
ENGINE
Fig. 90
4.
Straightness: The connecting rod bore taper should
not exceed .0005",
Figure 91
This inspection of the connecting rod can be made
using the precision gauge furnished with honing machine,
SE2218, Figure 92, or other accurate bore gauge such as SE-
2087. For further information refer to the instructions
furnished with the gauge.
If the original connecting rod does not meet the
foregoing requirements, it must be replaced.
Fig. 92 Checking Connecting Rod Bore Using Precision
Gauge Furnished with Honing Machine SE-2218
1.
Bore gauge
2.
Connecting rod
The connecting rod must be thoroughly cleaned and
visually inspected for defects. The connecting rod bushings
should be checked for proper clearance with the piston pin.
See "Specifications." The connecting rod bushings should be
checked for proper clearance with the piston pin using the
precision gauge furnished with honing machine, SE-2218,
Figure 93, or other accurate bore gauge such as SE-2087.
Fig. 93 Checking Connecting Rod Bushing Bore Using
Precision Gauge Furnished with Honing Machine
1.
Bore gauge
2. Connecting rod
CGES-210 Page 33
PRINTED IN UNITED STATES OF AMERICA
|
