|
| |
ENGINE DIVISION SERVICE MANUAL
TM 5-4210-230-14&P-1
ENGINE
33.
Remove two bolts and flat washers from engine water
outlet, Figure 34. Remove engine water outlet,
thermostat and gasket from engine.
34.
Remove water temperature sender unit Figure 34.
35.
Remove water inlet housing and gasket by removing
bolts and washers securing them to the crankcase,
Figure 35.
Fig. 34 Thermostat and Sender Unit Removal
1. Engine water outlet
2. Bolts
3. Water temp. sender unit
Fig. 35. Water Inlet Housing Removal
1. Water inlet housing
2. Bolts
36.
Remove twelve mounting bolts and flat washers
securing intake manifold to cylinder heads, Figure 36.
Remove intake manifold.
Fig. 36 Intake Manifold Removal
1. Cylinder heads
2. Intake manifold
3. Mounting bolts
37.
Remove any dirt or foreign matter that may have
accumulated around the top edge of the tappet cover;
then remove tappet cover and intake manifold gasket
assembly, Figure 37.
NOTE: The tappet cover and intake manifold
gaskets are serviced as one unit.
Fig. 37 Removing Tappet Cover and Intake Manifold Gasket
Assembly
1. Roll pins
2. Tappet cover and intake manifold gasket
assembly.
CGES-210 Page 17
PRINTED IN UNITED STATES OF AMERICA
|
