|
| |
ENGINE DIVISION SERVICE MANUAL
TM 5-4210-230-14&P-1
Fig. 24 Removing Lower Oil Seal
(Distributors for V-537 Engine)
1. Seal
3.
Install bushing remover SE-1955-5 in upper bushing
(Figure 25).
Fig. 25 Bushing Remover SE-1955-5 Installed in Upper
Bushing
1. Upper Bushing
2. Remover
4.
Place distributor housing on press bed. Insert knock-
out bar through lower bushing and allow it to rest on
bushing remover already installed in upper bushing.
Press upper bushing from housing by pressing
against knock-out bar (Figure 26).
The knock-out bar can be made locally from cold
rolled bar stock, 11mm (7/16 in.) in diameter by 30
cm (12 in.) long.
Fig. 26 Pressing Out Upper Bushing Using Knock-Out
Bar
1. Knock-Out Bar
2. Press Ram
5.
Install bushing remover SE-1955-5 in lower bushing
(Figure 27).
Fig. 27 Bushing Remover SE-1955-5 Installed in Lower
Bushing
1. Remover
CGES-145-U Page 13
PRINTED IN UNITED STATES OF AMERICA
|
