|
| |
TRUCK SERVICE MANUAL
TM 5-4210-230-14&P-1
BODIES AND CABS
Legend for Figure 19
Key
Description
Key
Description
1
Door, Assembly, Cab
7
Rod, Lock Knob to Latch
2
Regulator, Assembly, Window
8
Clip, Rod End
3
Screw, Mounting, Pan Head
9
Latch, Assembly, Door
4
Control Assembly, Remote
10
Retainer, Rear Run Channel
5
Screw, Mounting
11
Bolt, Mounting, Hex Head
6
Rod, Remote Control to Latch
12
Rod, Lock Cylinder to Latch
IMPORTANT
Be careful when reinstalling door glass, door glass regulator and related parts to avoid glass breakage. Door glass
inner and outer seals, channel seals and glass mounting fasteners have been designed to protect glass through
rugged operating conditions. Make sure the reassembly of these parts will maintain this same glass protection.
DOOR LATCH ASSEMBLY AND REMOTE CONTROL
The cab door latch assembly (Figs. 19 and 20) used
with this door features positive norattle latch jaws which
engage with striker pin on cab lock pillar. Latch assembly
mounts to a small opening in edge of door and connects to
remote control, lock cylinder and lock knob by relay control
rods.
Remove
1.
Remove door hardware, trim and access door (same
as for removing door glass).
2.
Remove lock knob from relay control rod through
window frame.
3.
Unfasten rod end clips and remove relay control rods
from remote control assembly and from lock cylinder
assembly. Opposite ends of the three relay control
rods can remain attached to latch assembly.
4.
Remove three socket head screws and detach
remote control from inside of door (Fig. 21).
5.
Remove five socket head screws and detach door
latch assembly from inside of door frame (Fig. 22).
Latch jaws should be closed.
CTS-2714 Page 14
PRINTED IN UNITED STATES OF AMERICA
|
