|
| |
TM5-4210-229-14&P
5-13.
STARTER REPAIR. (Continued).
e.
Install snapring (7) into groove on armature shaft.
f.
Install thrust washer (8) on shaft (1).
g.
Position retainer (6) and thrust washer (8) with snap
ring (7) in between. Using two pliers, grip retainer
(6) and thrust washer (8) or collar and squeeze until
snap ring (7) is forced into retainer (6) and is held
securely in groove in armature shaft (1).
h.
Lubricate drive gear housing bushing with lubricant
(Appendix D, Item 32).
i.
Engage shift lever yoke with clutch and slide
complete assembly into drive gear housing (9).
j.
Install the center bearing screws (10) and the shift
lever (11), and pivot bolt (12).
k.
Install solenoid assembly (13).
l.
Position field frame (14) against drive gear housing
(9) on alignment pin using care to prevent damage
to brushes.
m. Lubricate commutator end frame bushing with
lubricant (Appendix D, Item 32).
n.
Install washer (15) on armature shaft and slide end
frame onto shaft (1). Install insulator (16) and then
end frame (17) onto shaft (1). Then install through
bolts (18) making sure they pass through bolt holes
in insulator (16).
o.
Connect the field coil connector (15) to the solenoid
terminal with screw (20).
5-35
|
