|
| |
TM5-4210-229-14&P
4-96. FRONT TURN SIGNAL LIGHT MAINTENANCE
This task covers:
a. Removal
b. Repair
c. Installation
INITIAL SET-UP
Tools
General Mechanics Tool Kit
Materials/Parts
Bulb (9417866)
General Safety Instructions
Engine OFF.
Transmission in (N) neutral.
Parking brake set.
Batteries disconnected.
REMOVAL
a. Disconnect wiring cable (1) from base of light assembly
(2).
b. Remove two nuts (3) and washers (4) from light
mounting
studs (5).
c. Remove light assembly (2) from fender.
d. Inspect light mounting pad (6) and replace if damaged
or deteriorated.
REPAIR
a. Remove lens mounting screws (7) and remove lens (8).
b. Press bulb (9) inward and turn counterclockwise to
remove bulb (9) from socket.
c. Inspect bulb socket. If rusty or corroded, replace light
assembly (2). Inspect lens gasket (10) and replace if
damaged.
d. Insert new bulb (9) in socket, press inward and turn
clockwise to lock in place.
e. Position lens (8) and gasket (10) on light body and in-
stall lens mounting screws (7).
INSTALLATION
a. Position mounting pad (6) and light assembly (2) on
fender.
b. Install two washers (4) and nuts (3) on light mounting
studs (5).
c. Plug wiring cable connector (1) into light assembly (2).
d. Tighten light mounting nuts (3).
e. Connect battery cables.
f. Check light operation.
4-109
|
