ALTERNATOR REPAIR - TM-5-4210-224-14-P0473

TM 5-4210-224-14&P

5-9. ALTERNATOR REPAIR (Continued).

h. Remove three nuts (23) which secure stator leads (24) to terminals (25d aemove stator (21).

) rn

i. Remove positive and negative output terminal bolts (11 and 12).

j. Remove three hex screws (26) and remove capacitor (27) connected between the heat sinks (28).

k. Remove two screws (29), lockwashers (30), guardwashers (31), and insulating washers (32) which retain lower

end of heat sinks (28).

l. Remove heat sinks (28) and note location of insulating washers (32) and bushings (33).

m. Remove two terminal stud bushings (34).

n. Using a bearing puller remove drive end housing (20) and bearing assembly (35) from the rotor shaft (19).

o. Remove four screws (36) and bearing retainer (37) and press bearing out of drive end housing.

p. With a heat gun remove wire (38) that connects the rotor coil (19) to the outside slip ring (39). Unsolder the wire

from the inside slip ring (40) and with a bearing puller remove the slip ring assembly and insulation washer (41).

q. Using a bearingpuller remove the bearing (42).

5-16