INSTALLATION - TM-5-4210-224-14-P0426

TM 5-4210-224-14 & P

4-236. SPINDLE REPLACEMENT. (Continued)

vise, placing the high-step diameter in the jaws

and removing the bearing seal (7) and shaft

bearing (6).

d. Remove the spacer (8), seal (9), and oil

deflector (10) from the axle shaft.

INSTALLATION

a. Relubricate the shaft bearing (6) and the spindle

(5) with a high melting point type wheel bearing

grease (Appendix D, Item 15)

b. Install the shaft bearing (6) and the bearing seal

(7) into the spindle (5) by using the driver

handle and bearing installer.

c. Install the oil deflector (10) and seal (9) onto the

axle shaft by placing the seal (9) onto the oil

deflector (10) with the deflector lip toward the

spindle.

d. Install the spacer (8) onto the axle shaft with the

chamfer points toward the oil deflector (10).

e. Install the spindle (5) onto the steering knuckle

(11) by sliding the spindle over the axle shaft

until it seats on the steering knuckle.

NOTE

The bolts must protrude through

the spindle.

f. Install the bracket (4), plate (3), washers (2) and

new nuts (1).

g. Torque the nuts (1) to 65 ft-lbs (88 N.m).

4-331