REMOVAL - TM-5-4210-224-14-P0413

TM 5-4210-224-14 & P

4-226. POWER STEERING SYSTEM MAINTENANCE (Continued).

REMOVAL

a. Loosen the pivot nut (1) and pump brace adjusting bolts (2).

b. Remove the pump belt (3) from the vehicle.

INSTALLATION

a. Install pump belt (3) over pulley.

b. Move the pump and bracket assembly outward, away from the engine.

c. Torque the pivot nut (1) and brace adjusting bolts (2) to 32 ft-lbs (44 N.m).

ADJUSTMENT

CAUTION

When adjusting a power steering pump belt, never pry against the pump reservoir or pull against

the filler neck.

a. Place the belt tension gauge midway between the pulleys on drive belt being checked.

NOTE

With old (used) belts, the tension should read 67 lbs (300 N). With a new belt, not having

operated on the engine, the tension should read 146 lbs (650 N).

b. Loosen the pivot bolt and pump brace adjusting nuts and adjust the belt to correct tension by moving the pump

outward, away from the engine.

c. Torque the pump bracket adjusting nut and the pivot bolt nut to 32 ft-lbs (44 N.m).

d. Check the belt tension to insure correct tension, then remove the gauge from the belt.

4-227. POWER STEERING GEAR REPLACEMENT

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

Tools

General Safety Instructions

General Mechanics Tool Kit

Engine OFF

Transmission in (N) neutral.

Materials/Parts

Parking brake and micro-brakelock set.

Steering Gear (016-90002)

4-318