VENT GLASS REPLACEMENT.

TM 5-4210-224-14&P

4-171. BACK WINDOW REPLACEMENT (Continued).

e. While the assistant holds the glass firmly in

f. Continue pulling the cord until it is free from the

place, pull one end of the cord, forcing the lip of the

weather-strip and the lip of the entire weather-strip is over

weather-strip up and over the flange of the opening.

the flange of the opening.

4-172. VENT GLASS REPLACEMENT.

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

Tools

Equipment Condition

Mechanical Window Press

Para.

Condition Description

Materials/Parts

4-176

Door Trim Panel Removed

Sandpaper, Fine (Appendix D, Item 38)

Soap Solution

General Safety Instructions

Rubber Lubricant (Appendix D, Item 24)

CAUTION: Always wear heavy gloves

Glass Channel Filler

when handling glass to minimize the

Curbside Glass (20264743)

risk of injury.

Streetside Glass (20264744)

REMOVAL

a. Using an oil can or similar means, squirt rubber

lubricant (Appendix D, Item 24) solvent on the

tar paper line filler (1) all around the glass

channel (2) or frame to soften the old seal.

b. When the seal has softened, remove the glass

(3) and old filler from the channel (2).

INSTALLATION

a. Thoroughly clean the inside of the glass channel

(2) with sand-paper (Appendix D, Item 38) to

NOTE

remove all rust and foreign matter.

Usually the following procedure is done

with a mechanical window press.

b. Cut the new piece of glass channel filler (1) 2

d. Squeeze together the doubled ends of the filler

inches (51mm) longer than required.

(1) which project beyond the edge of the glass

(3).

c. Place the filler (1) soapstoned side of filler away

e. Brush the inner channel (4) with soap solution.

from glass, evenly around and over the edge of

the glass (3) that will be inserted into the

NOTE

channel (2).

Do not use grease or oil.

4-233