|
|
TM 5-4210-224-14&P
4-164. INSIDE DOOR HANDLE REPLACEMENT (Continued).
INSTALLATION
a.
Position the inside door handle and connect
the control rod (4) by placing the rod into the
clip and lever, then slide the clip so that the
small diameter slot is in line with the lock
rod.
b.
Install the handle to door screws (2).
c.
Install the door handle seal (4).
d.
Install door trim panel (paragraph 4-176).
4-165. DOOR WEATHERSTRIP REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
General Safety Instructions
General Mechanics Tool Kit
Engine OFF
Transmission in (N) neutral
Materials/Parts
Parking brake and micro-brakelock set.
Weatherstrip (1402777)
REMOVAL
a.
Open the door and remove the sill plate at
the bottom edge of door opening.
b.
Remove the weatherstrip (1) by pulling it
away from the pinchweld flange.
INSTALLATION
NOTE
Remove all rust, road dirt, grease,
oil, old cement and bits of old
weatherstrip from the edge of the
opening.
b.
Trim weatherstrip
(1)
and
butt
ends
together.
a.
Install the weatherstrip (1) to the pinchweld
flange, starting at the bottom center of the
c.
Install the sill plate to the vehicle.
door opening.
4-222
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |