 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 4-145. TURN SIGNAL SWITCH REPLACEMENT. (Continued)
h.
Put the turn signal switch in the "neutral"
m.
Remove the turn signal switch by pulling the
position.
switch straight up, guiding the wiring
harness and cover through the column
i.
Pull "out" on the hazard warning knob.
housing.
j.
Install the washer, upper bearing preload
INSTALLATION
spring and cancelling cam onto the upper
end of the shaft.
NOTE
Be sure the wiring harness is on
k.
Install the lock plate onto the end of the
the protector.
shaft.
a.
Feed the connector and cover down through
l.
Screw the center post of the lock plate
the housing and under the mounting
compressor onto the steering shaft as far as
bracket.
it will go.
CAUTION
m.
Place a new retaining ring over the center
Use only the specified screws,
post.
bolts, and nuts at assembly. The
use of over length screws could
n.
Place the "C" bar over the center post and
prevent a portion of the assembly
then compress the lock plate by turning the
from compressing if impacted.
nut clockwise.
b.
Install the cover on the harness.
o.
Slide the new retaining ring down the
tapered center post and into the shaft
c.
Install the turn signal mounting screws (4).
groove.
d.
Clip the connector to the bracket on the
p.
Remove the lock plate compressor.
jacket.
q.
Install the cover on the lock plate and snap
e.
Install the instrument panel trim plate.
into position.
f.
Install the hazard warning knob (3).
r.
Install the steering wheel (paragraph 4-142).
g.
Install the turn signal lever (2) and screws
s.
Reconnect the battery cables.
(1).
4-199
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals