|
|
TM 5-4210-224-14&P
Table 2-5 Operator Preventive Maintenance Checks and Services - Continued
D - Daily
W - Weekly
A-
After
M-
Monthly
PROCEDURES
EQUIPMENT IS
INTERVAL
ITEM
ITEM TO BE
Check for and have repaired
NOT READY/
NO. D A W M
INSPECTED
or adjusted as necessary
AVAILABLE IF
EMISSION CONTROL SYSTEM
32
q Pump, CDR
Visually inspect the vacuum pump, CDR valve,
Valve, Tubing
tubing and hoses for corrosion or structural
and Hoses
damage.
ENGINE ACCESSORIES
33
q Batteries
Visually inspect battery terminals for corrosion.
Clean as necessary. Visually inspect battery
hold down for tightness and corrosion.
34
q Oil Pan
Visually inspect oil pan for corrosion or
structural damage. Check for signs of leakage
around drain plug.
ENGINE COMPARTMENT FLUID LEVELS
35
Windshield
Check windshield washer fluid reservoir level.
q
Washer Fluid
Replenish windshield washer fluid as necessary.
36
Brake Fluid
Check master cylinder fluid level in both reservoirs.
Fluid level is
qq
Brake fluid level should be filled
low.
to a point about x inch (6mm) below lowest
edge. Refer to next higher level of maintenance
for service.
37
Oil Level
Check engine oil level. If oil level is below
Oil level is
qq
"ADD" line, refer to next higher level of maintenance
low.
for service.
38
Power Steering
Check power steering fluid level. If the power
qq
Fluid Level
steering fluid is warm, the fluid level should
be between the "HOT" and "COLD" marks on the
filler cap indicator. If cool, the fluid level
should be between the "ADD" and "COLD" marks.
Refer to next higher level of maintenance for
service.
39
Transmission
Check the transmission fluid level. Fluid level
Fluid level is
q
Fluid Level
in the clutch master cylinder reservoir should
low.
reach the bottom of the diaphragm when it is in
place in the reservoir. Refer to next higher
level of maintenance for service.
CAB ASSEMBLY
40
Mirrors
Inspect mirrors for cracks, dents, or other damage.
qq
Inspect for loose or missing attaching hardware.
41
q *Doors
Check operation and general condition of cab
q
doors. Inspect door seals for tears, cracks, or
loose sealing gaskets.
2-38
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |