|
| |
TM 5-4210-220-34
2-11.
HOSE BODY - Continued
(11)
To install upper panel onto new compartment boxes, measure and scribe the following dimensions as
shown. Measure 1.7 in. (4.3 cm) from the forward most edge of compartment box (D). Measure in 14
in. (35.6 cm) from the outer face of each compartment box (C, E, F, and D).
(12)
Position upper panel so that it is adjacent to
scribe marks. Make sure upper panel is
inboard of scribe marks. Secure upper
panel to compartment boxes using
lockbolts. If compartment boxes are new,
use upper panel as a drill template.
(13)
Attach fender skirt to compartment box (B)
using lockbolts.
(14) If all repairs are completed, reassemble hose
body
by
attaching
the
following
subassemblies
- Rear Panel Assembly (see d. preceding)
- Front Panel Assembly (see c. preceding)
- Hose bed (see b. preceding)
- Compartment Tops (see a. preceding)
f.
Left Hand Compartment Assembly Repair
NOTE
To disassemble the left hand side compartment assembly, it must first be separated from the hose body
assembly. To separate the left hand compartment assembly remove the following subassemblies
Compartment Tops (see a. preceding)
Hose bed (see b. preceding)
Front Panel Assembly (see c. preceding)
Rear Panel Assembly (see d. preceding)
(1)
Separate
the
upper
panel
from
the
compartment boxes by removing lockbolts.
(2)
Separate
the
lower
panel
from
the
compartment boxes by removing lockbolts.
(3)
Remove
lockbolts
that
retain
the
box
assemblies as a group. Separate the boxes
from each other by removing lockbolts. Using
illustration,
remove
compartment
boxes
following alphabetical order.
Do not remove rivets because they hold the
compartment panels together.
(4)
Replace fender skirt as necessary, see para. 2-11.1.
NOTE
Apply sealant (item 25, Appendix B) to all metal mating surfaces prior to installation.
2-61
|
