|
| |
TM 5-4210-220-34
3-8.
ENGINE Continued
3-8.6
Flywheel Housing.
INSTALLATION
(1)
Lubricate the gear train teeth with engine oil
(item 17, Appendix B).
(2)
Affix a new gasket (2) to the flywheel
housing (1). Hold in place with petroleum
jelly (item 21, Appendix B).
(3)
Thread alining studs J1927-01 into the
cylinder block (3) to guide the flywheel
housing (1) in place.
(4)
Before installing the flywheel housing, be
sure the 5/8 in. -1 1 x 1 in. rear end plate-
to-cylinder block bolt (4) is installed. Tighten
the bolt to 110 ft lb (149 Nm).
(5)
Attach lifting eyes to the mounting pads.
WARNING
Serious injury could occur if heavy equipment is moved/lifted without sufficient personnel to do the job.
Use proper physical lifting procedures or use a suitable lifting device or dolly. Wear safety shoes, gloves
and other suitable protective clothing.
Death or serious injury could occur if unauthorized or unnecessary personnel are in the hoisting area.
Permit only personnel actually engaged in the hoisting operation to be near the vehicle and hoisting
equipment. All instructions for the hoisting operations must come from one authorized person.
(6)
Using a suitable lifting sling and an overhead crane, position the flywheel housing (1) over the alining studs
and crankshaft. Push the housing up against the cylinder block end plate and gasket (2).
(7)
Install three new flywheel housing nylon patch bolts at the right camshaft gear area, position 13, 14 and 15 as
shown.
(8)
Draw the flywheel housing towards the end plate by gradually tightening the bolts (with washers and
lockwashers) in the following sequence; 12, 10, 11, 1, 2, 5, 6, 3, 4, 13, 23, 14, 15, 16, 17, 18, 19, 20, 21, 22,
30, 33, 27, 26, 25, 24, 32, 31, 29, 28, 9, 7, 8.
3-138
|
