|
| |
TM 5-4210-220-34
3-7.
TRANSMISSION - Continued
WARNING
Place a suitable container beneath the
flywheel to catch any oil which may drain
during removal of the flywheel.
(2)
Remove twenty-nine of the thirty bolts and
washers that retain the flywheel on the
converter pump.
(3)
Install lifting tool J24365 onto the flywheel
assembly.
(4)
Attach a hoist to the lifting tool. Support the
weight of the flywheel during removal of the
remaining bolt and washer.
(5)
Remove the flywheel and attached parts
from the converter housing.
CAUTION
Whether the turbine is removed with the
flywheel as shown, or remains on the
transmission, use care to prevent it
falling.
(6)
Holding the stator assembly, lock the stator
and the freewheel roller race together by
rotating the stator in a counterclockwise
direction as shown.
(7)
Carefully lift the stator assembly from the
turbine shaft.
(8)
Holding the safety guards of tool J26598-A
(1) open, place the tool over the converter
ground sleeve (2) and snap ring.
(9)
Position the jaws into the snap ring gap
(10) Close the jaws by rotating the adjusting nut.
(11) Release the safety guards by rotating the
tool arms. Rotate the adjusting nut to the
stop nut.
3-10
|
