|
| |
TM 5-4210-220-34
2-19.
ENGINE - Continued
2-19.10
Oil Pump - Continued
(9)
Install the cover attaching capscrews (20), and lockwashers (21). Tighten the 3/8 - 16 capscrews to 28 ft lb
(38 Nm) and tighten the 1/2 - 13 capscrews to 80 ft lb (108 Nm).
(10
Affix a new gasket (17) to the flange on the oil pump inlet tube (15). Attach tube to the bottom of the
crankshaft cover (16) using capscrews (13), and lockwasher (14). Tighten capscrews to 28 ft lb (38 Nm).
(11)
Install key (12) into crankshaft (11).
(12)
Lubricate the end of the crankshaft (11) and the crankshaft pulley (10) using engine oil (item 17, Appendix B).
(13)
Slide the crankshaft pulley (10) on the crankshaft (11).
(14)
Place the washer (9) over the pulley retaining bolt (8) and thread the bolt into the end of the crankshaft
fingertight.
(15)
Attach the front engine supports (2) to the crankshaft front cover using capscrews (7).
(16)
Aline snubbing washer (5) with left hand vibration isolator and install capscrew (6), and similarly the right hand
side.
(17)
Install washers (4), and nuts (3) onto both capscrews (6).
(18)
Tighten engine mount-to-cover capscrews (7) to 80 ft lb (108 Nm).
(19)
Remove all engine supports, and allow engine weight to rest on cross member.
2-232
|
