|
| |
TM 5-4210-220-12
4-11. HEAT SHIELDS - Continued
4-11 1 Front Heat Shields - Continued
REPAIR
(1)
Oversized or cracked mounting holes can be repaired by installing oversized washers over them. If patches are
needed, report to Direct Support Level for repair.
(2)
Dents can be straightened by bumping them with a soft plastic hammer while using a block of wood as backing.
(3)
Make sure the pump body heat shield drain hole is not plugged.
(4)
Replace heat shields that cannot be repaired.
(5)
Clean and paint repaired area or new heat shield as detailed in para. 4-9.
4-74 /(4-75 Blank)
|
