|
| |
TM 5-4210-218-13&P
4-15 AGITATOR BRACKET REPLACEMENT. (Refer to Figure 4-7)
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP
Equipment Condition
Tools
Reference
General Mechanics Tool Box, Item 1, Section
Cover removed from Recovery / Recharger
III, Appendix B.
paragraph 2-6.1
Materials/Parts
Air supply disconnected, paragraph 2-7
Self-locking nuts
Agitator bracket
4-15.1 Removal.
a.
Loosen setscrew (1) in collar (2).
b.
Pull bracket (3) out of collar (2). Retain collar for reuse.
c.
Loosen setscrew (4) in collar (5) and slide collar off shaft.
d.
Remove two nuts (6), washers (7) and bolts (8), two straps (9), and two guides (101 from bracket. Discard
nuts (6).
e.
Dispose of bracket (3).
4-15.2 Installation.
a.
Using replacement bracket, install two straps (9) on bolts (8) and locate in holder in bracket.
b.
Install two guides (10), washers (7), and nuts (6) and secure all items to bracket.
c.
Install one collar (5) and setscrew (4) on shaft. Do not tighten setscrew.
d.
Install assembly shaft through bearing and place collar (2) and setscrew (1) on shaft end.
e.
Adjust bracket for proper position on scale and secure by tightening both collar setscrews.
4-17
|
