|
| |
TM 5-4210-218-13&P
CHAPTER 4
UNIT MAINTENANCE INSTRUCTIONS
SECTION I. REPAIR PARTS, SPECIAL TOOLS, AND SUPPORT EQUIPMENT
4-1 COMMON TOOLS AND EQUIPMENT.
For authorized common tools and equipment refer to the Modified Table of Organization and Equipment (MTOE)
applicable to the unit authorized to have the Recovery / Recharger Unit.
4-2 SPECIAL TOOLS AND SUPPORT EQUIPMENT.
Special tools required for maintenance of the Recovery / Recharger Unit are listed in Appendix B. No support equipment
is required for maintenance of the Recovery / Recharger Unit.
4-3 REPAIR PARTS.
Repair parts are listed and illustrated in Appendix C to this manual.
SECTION II. SERVICE UPON RECEIPT
4-4 EQUIPMENT UNPACKING AND INSTALLATION.
4-4.1 Packaging Data. The Recovery / Recharger Unit is shipped partially assembled in a large shipping container. This
container may be moved using a forklift. The Recovery / Recharger Unit is shipped in the following condition.
a.
All components are assembled and mounted on the base with the exception of the hoist winch assembly, and the
scale assembly. The hoist winch assembly is placed across the top of the equipment during shipment. The scale
assembly is strapped to the lid of the tool box.
b.
The tilt rack assembly is secured in the non-inverted position with the tilt rack lock down chain.
c.
The nitrogen pressure regulator is attached securely to the shaker bracket with two U-bolts.
d.
All tools and loose hardware are stored in the tool box.
4-4.2 Site and Shelter Requirements.
a.
The Recovery / Recharger Unit does not have particular site requirements but must be positioned close to a
compressed air source with a capability to provide air at a maximum of 175 psi at 15 CFM.
4-1
|
