Click here to make tpub.com your Home Page

Page Title: Motor-Generator Set
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

heater.  If the heater still does not
(3) Preheating takes place for approximately
operate properly, shut the unit off
one minute, after which time the ignition
and check for the difficulty, following
cycle starts, and the combustion blower
instructions  in  maintenance  and
operates.  After approximately another
repair.
minute, the heater will circulate warm air,
and the control box indicator lamp will
b. Stopping. Position the control switch in the OFF
glow to indicate that the heater is
position.
operating properly.
Caution
Note
Do not use the circuit breaker to stop
For one minute after the control
the heater as the system will not
switch is turned on, the heater will
purge when all circuits are open.
give no visible or audible signs of
operation until the preheater element
Note
heats the burner sufficiently to cause
When the control switch is in the
If the control box
OFF  position,  the  heater  will
indicator lamp glows 1/2 to 2 minutes
continue to operate through the
after the heater was turned on, the
purge cycle. The indicator lamp will
heater is operating properly.  If the
glow for approximately two minutes
indicator lamp does not glow, air
after  shutdown,  until  the  heater
may be trapped in the fuel line,
starts to cool.
preventing  sufficient  fuel  from
reaching the heater during the timed
172. Motor-Generator Set
ignition cycle.
This may happen
when the heater is started for the
a. Starting.  Connect the 50-foot cable supplied
first time after installation or at the
with the winterization kit or equivalent to the motor-
beginning of the heating season. If
the indicator lamp does not light
generator set receptacle (fig. 71.18) and 115 volt ac
after three minutes, turn the control
electrical source.
switch to OFF AG0 SW7A position.
b. Stopping. Disconnect the cable.
Check the reset button in the control
box. Wait five minutes, then restart
17

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business