|
| |
TM 10-4210-235-13
4-25. SKID FRAME REPAIR
This task covers:
a.
Disassembly
b.
Repair
d.
Replacement
INITIAL SETUP:
Tools
Equipment Condition:
General Mechanics Tool Kit, Appendix B, Section HI,
Remove cylinders (para 4-11).
Item 1
Remove rods (para 4-22 and 4-24).
Materials/Parts
General Safety Instructions
Lock Washers (10), Appendix H, item 8
Lock Washers (16), Appendix H, item 9
WARNING
Safety Solvent Cleaner, Appendix E, Section II, item 1
ù Keep safety solvent cleaner away from sparks or
flame. The solvent cleaner is flammable and the
Rags, Appendix E, Section II, item 2
vapors can be explosive.
Adhesive, Appendix E, Section II, item 3
ù Use safety solvent cleaner in a well ventilated area.
Wear gloves and eye protection when using solvent
cleaner. Repeated or prolonged skin contact or
inhalation of solvent cleaner vapors can be toxic.
a.
Disassembly (See figure 4-27.)
(1)
Remove two bushings (1).
(2)
Remove 16 nuts (2), lock washers (3), flat washers (4), screws (5), and slide buttons (6). Discard lock
washers.
(3)
Remove two sets of pads (7).
WARNING
ù Keep safety solvent cleaner away from sparks or flame. The solvent cleaner is
flammable and the vapors can be explosive.
ù Use safety solvent cleaner in a well ventilated area. Wear gloves and eye
protection when using solvent cleaner. Repeated or prolonged skin contact or
inhalation of solvent cleaner vapors can be toxic.
(4)
Remove any adhesive remaining on frame (8) surface using safety solvent cleaner and a stiff brush or rag.
(5)
Be sure frame (8) surface is clean and free of any dirt or oils.
b.
Repair
Repair is limited to replacement of defective or damaged components only.
4-62
|
