|
| |
ENGINE DIVISION SERVICE MANUAL
TM 5-4210-230-14&P-1
1. Change Engine Oil and Filter
a.
Remove oil drain plug from bottom of oil pan and drain oil.
b.
Service oil filter.
Procedure for servicing the spin-on type oil filter is as follows:
(1)
Remove oil filter assembly by turning counterclockwise with the hands or a suitable tool. Clean filter mounting pad.
(2)
Coat the gasket on the new filter with a film of grease.
(3)
Place the new filter in position on the center tube. Hand tighten 1/2 to 3/4 of a turn after gasket first contacts base of
mounting pad.
c.
Add sufficient oil to bring the oil level between "ADD" and "FULL" marks on oil dipstick (Fig. 2).
d.
Start engine and run for at least five minutes to warm oil and check for leaks. Recheck and add sufficient oil to bring oil level
between "ADD" and "FULL" marks on the oil dipstick.
Oil types and grades recommend for IH engines are as follows:
GASOLINE ENGINES
Temperature
Straight Viscosity Grade
Multi-Viscosity Grade
20 to 120F
SAE 30
SAE 10W-30, 10W-40, 20W-40, 20W-30
(-7 to 49C)
0 to 90 F
SAE 20W
SAE 10W-30, 10W-40, 20W-40, 20W-30
(-18 to 32C)
-10 to 70F
SAE 10W
SAE 10W-30, 10W-40
(-23 to 21C)
Below -10F (23C)
-------
SAE 5W-10, 5W-30
Use engine oils meeting service classification "SE" or "CC" (MIL-L-46152).
IMPORTANT
When a universal engine oil (SE-CD) is preferred, the engine oil must have passed the Volvo B-20 cam and
tappet test and contain a minimum 0.1% alkyl zinc. IH No. 1 engine oil meets this requirement.
CGES-215 Page 6
PRINTED IN UNITED STATES OF AMERICA
|
