DOOR OUTER HANDLE

TRUCK SERVICE MANUAL TM 5-4210-230-14&P-1 BODIES AND CABS DOOR OUTER HANDLE The door outer handle (Fig. 23) is a combination handle and lever operating assembly that connects with the latch assembly mechanism inside door to actuate the latch jaws. Outer handle can be removed without removing latch assembly. Fig. 23 Door Outer Handle and Lock Cylinder Remove 1. Remove door hardware, trim and access door (same as for removing door glass). 2. Remove three hex nuts from studs through door from rear of handle. 3. Remove door outer handle from door (Fig. 24). Install To install outside door handle, reverse foregoing removal procedure. DOOR LOCK CYLINDER ASSEMBLY The door lock cylinder (Fig. 23) is key coded to key switch on instrument panel so that one key operates both. If keys are lost or a replacement of lock cylinder is desired, see special instructions under "KEY SWITCH AND DOOR LOCK CYLINDER REPLACEMENT". Remove 1. Remove door hardware, trim and access door (same as for removing door glass). 2. Disconnect rod end clip and detach control rod from door lock cylinder assembly. Fig. 24 Removing Door Outer Handle Fig. 25 Removing Lock Cylinder Retainer IMPORTANT Lock cylinder retainer can be removed without removing glass rear run channel. Channel removed in Fig. 25 for clarity. CTS-2714 Page 16 PRINTED IN UNITED STATES OF AMERICA