|
| |
TM 5-4210-220-12
4-24. ELECTRICAL SYSTEM - Continued
4-24.3 Wiring Harness - Continued
b.
Wire Repair
NOTE
If only a single wire has failed, replace that wire as detailed in test preceding.
c.
Terminal Repair
(1)
All harness terminals are of the crimp type. If one or more has broken off, replace with an identical
connector.
(2)
Always use correct crimping tool when installing crimp connectors. No wires should be soldered for any
reason as this can lead to premature failure of the connection since all flexibility is taken out of the wire at
the point of solder.
4-425
|
