Table 2-1. Initial Receipt Inspection (IRI) or Prestorage Inspection (PSI)

SB 740-95-700

re-inspected, all samples that have been inspected and

2-5.

Inspection. Conduct all inspections and tests

then packed and resealed in barrier material.

under the control of a qualified inspector (see para 1-

(2) Reseal barrier material using the

3b(12)). The inspections and tests normally will be con-

instructions furnished with the material, printed on the

ducted at the surveillance inspection area; however,

material, or furnished with the sealing iron.

when authorized, examinations or tests may be per-

(3) Return serviceable samples to storage

formed at the storage site or elsewhere, but must be

with the parent lot.

within the limitations of all safety and security

(4) Segregate samples with critical or

requirements.

major defects or samples that cannot be returned to the

a. Initial Receipt Inspection (IRI).

original package configuration and report in the remarks

(1) Frequency. Perform this inspection on

section, Part II, Block 13, of DA Form 984, Munitions

an occurrence basis (see para 1-3b(7)).

Surveillance Report. See paragraph 2-9a(1), Part II (h)

(2) Classification of defects. Use Table 2-

of this bulletin.

1 to evaluate the incoming material.

Table 2-1. Initial Receipt Inspection (IRI) or Prestorage Inspection (PSI)

Defect

Inspection

Category Number Number

Method

Critical:

None defined.

Major:

101

Item damaged, incomplete, or improperly documented.

Visual

102

Preservation, unit packing, or packing damaged or deteriorated to the extent that adequate

protection

Visual

is no longer afforded to the item or handling and storing wo uld be adversely affected.

103

Item unit packing, or packing contaminated, wet, or mildewed as a result of adverse shipping

conditions.

Visual

104

Preservation, unit packing, packing, or marking incorrect.

Minor:

201

Slight damage to preservation, unit packing, or packing but not affecting the protection.

(3) Reporting. Using DA Form 984 and

just be- fore OCONUS shipment of the item.

(2) Examination and test. When one-half

the instructions in paragraph 2-9. In addition, report

or more than one-half of the cyclic period (defined by the

failure data and discrepancies encountered on SF 368,

IFC) has passed since the last inspection, or the cyclical

Quality Deficiency Report, per AR 702-7. See para-

graph 2-9a(3) of this bulletin.

period has been exceeded, or the date of the last

b. Prestorage Inspection (PSI).

surveillance inspection is unknown then perform a

complete inspection of the item by appendix A

(1) Frequency. This inspection shall be

instructions including any applicable appendix (TRC) of

per- formed on an occurrence basis if a change of

this bulletin. When less than one-half of the cyclical

condition and/or status of the item has taken place since

period has passed, perform only a visual examination by

the IRI.

appendix (TRC) instructions.

(2) Examination and test.

When the

(3) Evaluation and reporting.

Make

serviceability status is unknown, perform the examination

evaluations and reports by paragraph 2-7 and 2-9

and test of the item by appendix A instructions, including

instructions.

any applicable appendix (TRC) of this bulletin. All lots

e. Special Inspection (SI).

Perform this

shall be examined for receipt condition using table 2-1.

inspection as directed by higher headquarters or

(3) Reporting. Use DA From 984 and the

instructions provided locally to satisfy local installation

instructions in paragraph 2-9.

requirements. This inspection may also be performed to

c. Cyclical Inspection (CI).

determine the economic advisability of conducting further

(1) Frequency. This inspection shall be

inspection (screening) on unsegregated items, returns

per- formed at the frequency indicated in appendix A by

from overseas, or used items that have not been

the IFC (see para 2-6e).

reconditioned. Reports prepared for local use are

(2) Examination and test. Perform the

authorized. Reporting, as in paragraph 2-9, is not

examinations and tests of the item by appendix A

required for this inspection except as may be directed by

instructions including any applicable appendix (TRC) of

higher headquarters.

this bulletin.

(3) Evaluation and reporting. Make evaluations and

reports per instructions in paragraph 2-7 and 2-9.

d. Pre-Issue Inspection (PII).

(1) Frequency. Perform this inspection

2-3