|
| |
TM 9-254
3-13.
Using Expendables - Continued
NOTE
In steps (1) through (3), refer to figure 3-32.
(1)
To prepare a surface for mounting a gasket, seal or pad, use a knife or chisel to peel and scrape away
old material.
(2)
Use a clean cloth, moist but not dripping, with a cleaning solvent and wipe the mounting surface clean of
old adhesive and dirt.
(3)
Use clean, dry cloth and wipe the mounting surface dry.
NOTE
In steps (4) through (6), refer to figure 3-33.
(4)
Using a paint brush, apply a thin even coat of adhesive to the gasket or seal and on the mounting
surface. Allow the adhesive to air dry completely.
(5)
Apply another thin even coat of adhesive to the gasket or seal and to the mounting surface. Allow
adhesive to air dry until it becomes tacky.
(6)
Press the gasket or seal in place and apply a firm even pressure over the entire surface
Figure 3-33. Applying Adhesives
3-32
|
