EXPLANATION OF COLUMNS IN THE MAC - TM-55-1925-292-14-P0332

TM 55-1925-292-14&P

0045 00

7. Remove/Install. To remove and install the same item when required to perform service or other maintenance

functions. Install may be the act of emplacing, seating, or fixing into position a spare, repair part, or module

(component or assembly) in a manner to allow the proper functioning of an equipment or system.

8. Replace. To remove an unserviceable item and install a serviceable counterpart in its place. "Replace" is

authorized by the MAC and assigned maintenance level is shown as the third position code of the Source,

Maintenance and Recoverability (SMR) code.

9. Repair. The application of maintenance services, including fault location/troubleshooting, removal/installa-

tion, disassembly/assembly procedures, and maintenance actions to identify trouble and restore serviceabil-

ity to an item by correcting specific damage, fault, malfunction, or failure in a part, subassembly, module

(component or assembly), end item, or system.

NOTE

The following definitions are applicable to the "repair" maintenance function:

Services. Inspect, test, service, adjust, align, calibrate, and/or replace.

Fault location/troubleshooting. The process of investigating and detecting the cause of

equipment malfunctioning; the act of isolating a fault within a system or Unit Under Test

(UUT).

Disassembly/assembly. The step-by-step breakdown (taking apart) of a spare/func-

tional group coded item to the level of its least component, that is assigned an SMR

code for the level of maintenance under consideration (i.e., identified as maintenance

significant).

Actions. Welding, grinding, riveting, straightening, facing, machining, and/or resurfac-

ing.

10. Overhaul. That maintenance effort (service/action) prescribed to restore an item to a completely serviceable/

operational condition as required by maintenance standards in appropriate technical publications. Overhaul

is normally the highest degree of maintenance performed by the Army. Overhaul does not normally return an

item to like new condition.

11. Rebuild. Consists of those services/actions necessary for the restoration of unserviceable equipment to a

like new condition in accordance with original manufacturing standards. Rebuild is the highest degree of

materiel maintenance applied to Army equipment. The rebuild operation includes the act of returning to zero

those age measurements (e.g., hours/miles) considered in classifying Army equipment/components.

EXPLANATION OF COLUMNS IN THE MAC

Column (1) Group Number. Column (1) lists FGC numbers, the purpose of which is to identify maintenance

significant components, assemblies, subassemblies, and modules with the Next Higher Assembly (NHA).

Column (2) Component/Assembly. Column (2) contains the item names of components, assemblies, subassem-

blies, and modules for which maintenance is authorized.

Column (3) Maintenance Function. Column (3) lists the functions to be performed on the item listed in column (2).

(For a detailed explanation of these functions refer to "Maintenance Functions" outlined above.)

Column (4) Maintenance Level. Column (4) specifies each level of maintenance authorized to perform each

function listed in column (3), by indicating work time required (expressed as manhours in whole hours or deci-

mals) in the appropriate subcolumn. This work time figure represents the active time required to perform that

maintenance function at the indicated level of maintenance. If the number or complexity of the tasks within the

0045 00-2