ASSEMBLY - TM-55-1925-292-14-P0182

TM 55-1925-292-14&P

0015 00

WARNING

Do not allow hydraulic fluid, engine oil, or cleaning solvents to come in contact

with unprotected skin or eyes. Prolonged skin contact can cause illness or injury.

Eye contact can cause serious injury. Always wear chemical protective gloves

and goggles when handling hydraulic fluid, engine oil, and cleaning solvents.

Failure to follow these precautions can result in illness or serious injury.

2. Remove the drain plug (figure 2, item 1), permitting the oil to drain from the pump into the suitable drain pan.

3. Remove the breather (figure 2, item 2) from the pump.

WARNING

Cleaning solvent is flammable and its vapor is potentially explosive. Do not use

cleaning solvent in the vicinity of spark, open flame, or excessive heat. Do not

use cleaning solvent in unventilated spaces. Failure to follow these precautions

can result in death or serious injury.

Do not allow cleaning solvent to come in contact with unprotected skin or eyes.

Prolonged skin contact can cause illness or injury. Eye contact can cause seri-

ous injury. Always wear chemical protective gloves and goggles when handling

cleaning solvent. Failure to follow these precautions can result in illness or seri-

ous injury.

4. Using dry cleaning solvent and wiping rags, clean the breather (figure 2, item 2).

ASSEMBLY

1. Place antiseizing tape on the drain plug's male pipe threads (figure 2, item 1).

2. Install the drain plug (figure 2, item 1) in the diesel engine-driven firefighting pump.

3. Fill the diesel engine-driven firefighting pump with mineral oil (ISO non-detergent 68) at the breather (figure 2,

item 2) until the oil level is in the center of the sight glass (figure 3, item 1).

4. Place antiseizing tape on the breather (figure 2, item 2) male pipe threads.

5. Install the breather (figure 2, item 2) on the firefighting pump.

6. Perform the Follow-On Service procedure at the end of this work package.

0015 00-4