|
|
TM 55-1905-243-24&P
7. Remove/Install. To remove and install the same item when required to perform service or other
maintenance functions. Install may be the act of emplacing, seating, or fixing into position a spare, repair
part, or module (component or assembly) in a manner to allow the proper functioning of an equipment or
system.
8. Replace. To remove an unserviceable item and install a serviceable counterpart in its place. "Replace" is
authorized by the MAC and assigned maintenance level is shown as the third position code of the Source,
Maintenance and Recoverability (SMR) code.
9. Repair. The application of maintenance services, including fault location/troubleshooting,
removal/installation, disassembly/assembly procedures, and maintenance actions to identify troubles and
restore serviceability to an item by correcting specific damage, fault, malfunction, or failure in a part,
subassembly, module (component or assembly), end item, or system.
NOTE
The following definitions are applicable to the "Repair" maintenance function:
Services Inspect, test, service, adjust, align, calibrate, and/or replace.
Fault location/troubleshooting The process of investigating and detecting the cause of
equipment malfunctioning; the act of isolating a fault within a system or Unit Under Test
(UUT).
Disassembly/assembly The step-by-step breakdown (taking apart) of a
spare/functional group coded item to the level of its least component that is assigned
an SMR code for the level of maintenance under consideration (i.e., identified as
maintenance significant).
Actions Welding, grinding, riveting, straightening, facing, machining, and/or
resurfacing.
10. Overhaul. That maintenance effort (service/action) prescribed to restore an item to a completely
serviceable/operational condition as required by maintenance standards in appropriate technical
publications. Overhaul is normally the highest degree of maintenance preformed by the Army. Overhaul
does not normally return an item to like new condition.
11. Rebuild. Consists of those services/actions necessary for the restoration of unserviceable equipment to a
like new condition in accordance with original manufacturing standards. Rebuild is the highest degree of
material maintenance applied to Army equipment. The rebuild operation includes the act of returning to zero
those age measurements (e.g., hours/miles) considered in classifying Army equipment/components.
A-3 Explanation of Columns in the MAC
Column (1) Group Number. Column (1) lists functional group code (FGC) numbers, the purpose of which is to
identify maintenance significant components, assemblies, subassemblies, and modules with the Next Higher
Assembly (NHA). End item group number shall be "00."
Column (2) Component/Assembly. Column (2) contains the item names of components, assemblies,
subassemblies, and modules for which maintenance is authorized.
Column (3) Maintenance Function. Column (3) lists the functions to be performed on the item listed in column
(2). (For a detailed explanation of these functions refer to "Maintenance Functions" outlined above.)
A-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |