DRAFT
TM 5-4210-249-13&P-2
0255
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
WARNING
ICON 72
Care must be taken when installing wire on arm and bracket. Wire is under tension
and must be held until safely repositioned. Failure to comply may result in injury to
personnel.
NOTE
Install washers as noted prior to removal.
48. Position cable wire (88) through pin (98).
NOTE
Install cable as noted prior to removal.
49. Install cable (96) on bracket (97) with two cushion clips (95), screws (94), four washers (93), two
lockwashers (92), and nuts (91).
50. Install retainer (90) on cable wire (88) and tighten screw (89).
CAUTION
Cable wire must be bent a minimum of 90 degrees. Failure to comply may allow
retainer to come loose and not allow primer cable to function.
51. Bend cable wire (88).
52. Install line (86) on elbow (87).
53. Install wire (84) on stud (85) with nut (83).
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
WARNING
ICON 30, 44, 27
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful
vapors, and are harmful to skin and clothing. To avoid injury or death, keep away
from open fire and use in well-ventilated area. If adhesive, solvent, or sealing
compound gets on skin or clothing, wash immediately with soap and water.
54. Apply electrical sealant on end of wire (84).
0255-31