DRAFT
TM 5-4210-249-13&P-2
0255
35. Remove pin (98) and washer (99) from arm (100).
36. Remove locknut (101) and two cables (102) and (103) from U-bolt (104). Discard locknut.
37. Remove four locknuts (105), two U-bolts (106), cradles (107), and bracket (97) from pipe assembly (71).
Discard locknuts.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
TFFT00581
38. Remove water tank fill valve (108) (WP 0299) and ground sweeps valve (109) (WP 0576) from vehicle.
39. Disconnect connector (110).
CAUTION
Air lines may be removed directly from elbows and fittings, or may remain attached
to elbows and fittings and removed as an assembly. If air lines are removed from
elbows and fittings, care must be taken not to damage air line. If sealing surface or
air line is damaged air line must be repaired or replaced.
NOTE
Valves shown have air lines remain attached to elbows.
40. Remove two elbows (111) and (112) and air lines (113) and (114) from eductor valve (115).
41. Remove two elbows (116) and (117) and air lines (118) and (119) from flush valve (120).
42. Remove four screws (121), lockwashers (122), washers (123), gasket (124), flange (125), and pipe
assembly (71) from pump (82). Discard lockwashers.
0255-9