DRAFT
TM 5-4210-249-13&P-2
0219
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
TFFT01584
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
WARNING
ICON 10
Keep out from under water pump engine when installing water pump engine in
pump house. Chains supporting water pump engine must be removed and
repositioned on engine lift points when sliding water pump engine into pump
house. Use extreme care when repositioning chains on engine lift points. If water
pump engine slips, sways, or falls, serious injury or death may result.
CAUTION
Make sure loose hoses and wires are secure and moved out of way so they do not
snag and cause damage when water pump engine is moved.
NOTE
Chains supporting water pump engine will need to be removed and repositioned during
the installation of the water pump engine.
Water pump engine must have rear motor mounts lifted off frame rails and frame rail
extensions approximately 1/16 in. whenever possible to allow for easier installation of
water pump engine.
After water pump engine is half way in pump house, 5 ft. (2 m) engine strap may need to
be removed and chain hoist will need to be attached directly to clevis to continue pulling
water pump engine into pump house.
14. With the aid of two assistants, operate chain hoist (1), and guide water pump engine (10) and remove and
reposition chains when needed to slide water pump engine (10) into pump house.
0219-30
