|
| |
TM 5-4210-233-14&P-1
5-11. ENGINE ASSEMBLY - Continued
(6)
Remove access plug (8) from driver's side of engine. Remove access plug (10) in bottom of flywheel
housing (11).
(7)
Turn lower pulley nut (12) clockwise while other person looks in access hole in engine. Stop turning
when bolt hole in engine flex plate is centered in access hole.
(8)
Reach through access hole in bottom to turn flywheel while other person looks in access hole in
engine. Stop turning when bolt hole in flywheel aligns with bolt hole in engine flex plate.
(9)
Install access plug (10) in bell housing (11).
(10) Install bolt to secure engine flex plate to flywheel through access hole in engine. Do not tighten bolt
fully at this time.
(11) Turn nut on lower pulley clockwise while other person looks in access hole in engine. Stop turning
when next bolt hole in engine flex plate is centered in access hole. Install bolt. Repeat process until all
twelve bolts are installed in flex plate.
(12) Torque twelve bolts to 95to 115 Ib-ft (130to 156 Nm). Install access plug (8) in engine.
5-53
|
