|
| |
TM 5-4210-233-14&P-1
4-209. APU ANTI-FLICKER POINTS AND RESISTOR
This task covers:
a.
Inspection
c.
Follow-on Maintenance
b.
Service
TOOLS REQUIRED
EQUIPMENT CONDITION
Tool Kit, General Mechanics, Automotive
Main Engine Shutdown (see para 2-12.)
(Appendix B, Section III, Item 1)
APU Shutdown (see para 2-16.)
Batteries Disconnected (see para 4-114.)
a.
Adjust.
(1)
Remove screw (1), lockwasher (2), anti-flicker
cover (3), and wire (4).
NOTE
Slightly burned points can be smoothed with a tile
or fine stone. Heavily damaged points must be
replaced.
(2)
Rotate crankshaft to maximum point opening
and check point gap with feeler gauge.
NOTE
Correct point gap is .025" (.64 mm).
(3)
Loosen and adjust stationary contact (5) to
correct gap of .025" (.64 mm).
4-522
|
