|
| |
TM 5-4210-233-14&P-1
4-194. OUTRIGGER EXTEND/RETRACT CYLINDERS
THIS TASK COVERS:
a.
Removal
c.
Follow-on Maintenance
b.
Installation
TOOLS REQUIRED
EQUIPMENT CONDITION
Too[ Kit, General Mechanics, Automotive
Main Engine Shutdown (see para 2-12.)
(Appendix B, Section 1II, Item 1)
APU Shutdown (see para 2-16.)
Batteries Disconnected (see para 4-114.)
PERSONNEL REQUIRED: 2
Outriggers Extended (see para 2-14.)
a.
Removal.
(1) Remove one bolt (2), one star washer (3) and pin (4) from outrigger (1).
(2) Remove nine screws (5) and outrigger panel (6).
(3) Tag and disconnect wires from side warning light (7).
(4) On opposite side remove two capscrews (8), two star washers (9), flatwashers (10) and cylinder cover
(11).
(5) Tag all hose and tube assemblies before disconnecting. Cap or plug all hose, tube, and fitting openings
to prevent entry of foreign matter.
(6) Remove tie wraps (12) from hydraulic hoses (13 and 14).
(7) Disconnect one hydraulic hose (13).
(8) Lift cylinder (15) from mount (16) and pull cylinder (15) out until remaining hydraulic hose (14) is
visible.
(9) Disconnect remaining hydraulic hose (14) and remove cylinder (15).
b.
Installation.
(1) Fully extend cylinder ram (15) and install hydraulic hose (14).
(2) Secure extended cylinder ram (1 5) to outrigger beam with pin (4), star washer (3), and bolt (2).
(3) Place cylinder (15) in rnount (16).
(4) Install hydraulic hose (13).
(5) Install tie wraps (12).
(6) Install cylinder cover (11), two star washers (9), flatwashers (10) and two capscrews (8).
(7) Connect warning light (7) wires tagged during removal.
(8) Install outrigger panel (6), nine screws (5).
c.
Follow-on Maintenance.
(1) Connect batteries (see para 4-114).
4-490
|
