|
| |
TM 5-4210-233-14&P-1
4-166. EXHAUST PIPE CLAMPS AND HANGERS - Continued
b.
Replacement of clamp "B"
(1) Support exhaust system while replacing clamps and hangers.
(2) Remove two nuts (9), washers (10), U-bolt (11) and clamp (12).
(3) Refer to para d. below for cleaning and inspection instructions.
(4) Install clamp (12) and U-bolt (11) and secure with two nuts (9) and washers (10).
c.
Replacement of clamps and hangers "C".
(1) Support exhaust system while replacing clamps and hangers.
(2) Remove nut (13), lockwasher (14), flatwasher (15) and screw (16). Remove band (17) from bracket
(18).
(3) Remove nut (19), four washers (20), two springs (21) and bracket (18) from bracket (22).
(4) Remove two nuts (23), lockwashers (24), flatwashers (25) and screws (26). Remove bracket (18) from
truck frame.
(5) Refer to para d. below for cleaning and inspection instructions.
(6) Position bracket (22) on truck frame and secure with two screws (26), flatwashers (25), lockwashers
(24) and nuts (23).
(7) Install two washers (20) and spring (21) on stud of bracket (18). Insert stud of bracket (18) through
bracket (22) and install two washers (20), spring (21) and nut (19). Tighten nut (19) until approximately
1/2" of threads is showing above nut (19).
(8) Install band (17) on muffler and align band (17) with bracket (18). Secure band (17) to bracket (18)
with screw (16), flatwasher (15), lockwasher (14) and nut (13).
4-447
|
