|
| |
TM 5-4210-233-14&P-1
4-140. ROCKER ARM COVERS - Continued
(5) Remove three screws (14), strainer (15), seal (16), tube (17), two S hooks (18), chain (19)
and cap (20) from left side rocker cover.
WARNING
Dry cleaning solvent P-D-680 is potentially dangerous. Avoid
repeated and prolonged breathing of vapors and skin contact
with the liquid. Do not use near open flame, arcing equipment or
other ignition sources. Always wear eye protection and
protective clothing. The flash point of P-D-680 is 100 to 138 deg.
F (38 to 59 deg. C).
WARNING
Death or serious injury could occur if compressed air is directed
against the skin. Do not use compressed air for cleaning or
drying unless the pressure is/has been reduced to 30 psi (2.11
kg/cm2) or less. When working with com- pressed air, always
use chipguards, eye protection, adn other personal protective
equipment.
(6) Clean strainer (15) and filtering disk (11) with solvent (Item 3, Appendix E) and air dry.
b.
Installation.
(1) Install cap (20), chain (19), two S hooks (18), tube (17), seal (16), strainer (15) and three screws (14) in
left side rocker cover.
(2) Install breather retainer (3), seal (13), retainer (12), filtering disk (1 1), retainer (10) and three screws
(9).
(3) Install gasket (8) and cover (7).
(4) Secure cover with two mounts (6), two washers (5) and two bolts (4).
(5) Install hose (2) on breather retainer (3) and tighten clamp (1).
C.
Follow-on Maintenance.
(1) Connect batteries (see para 4-114).
(2) Close engine compartment covers.
4-409
|
